Initial Profile Sources

profile_sources/non-prusa-fff/PapapiuLab/printer/_common_.ini

@@ -0,0 +1,65 @@
+[printer:*common*]
+before_layer_gcode = ;BEFORE_LAYER_CHANGE\n;[layer_z]\nG92 E0\n;{if layer_num == 2 }SET_FILAMENT_SENSOR SENSOR=my_sensor ENABLE=1{endif}\n\n
+between_objects_gcode = 
+color_change_gcode = M600
+cooling_tube_length = 5
+cooling_tube_retraction = 91.5
+default_filament_profile = "Generic PLA @Papapiu"
+default_print_profile = "0.20mm NORMAL @Papapiu"
+deretract_speed = 40
+end_gcode = PRINT_END
+extra_loading_move = -2
+extruder_colour = ""
+gcode_flavor = marlin
+high_current_on_filament_swap = 0
+layer_gcode = ;AFTER_LAYER_CHANGE\n;[layer_z]\n
+machine_limits_usage = time_estimate_only
+machine_max_acceleration_e = 5000
+machine_max_acceleration_extruding = 9000
+machine_max_acceleration_retracting = 9000
+machine_max_acceleration_travel = 12000,12000
+machine_max_acceleration_x = 12000
+machine_max_acceleration_y = 12000
+machine_max_acceleration_z = 100
+machine_max_feedrate_e = 60
+machine_max_feedrate_x = 500
+machine_max_feedrate_y = 500
+machine_max_feedrate_z = 10
+machine_max_jerk_e = 5
+machine_max_jerk_x = 5
+machine_max_jerk_y = 5
+machine_max_jerk_z = 0.4
+machine_min_extruding_rate = 0
+machine_min_travel_rate = 0
+min_layer_height = 0.05
+nozzle_diameter = 0.4
+parking_pos_retraction = 92
+pause_print_gcode = M601
+print_host = 
+printer_notes = ""
+remaining_times = 1
+retract_before_travel = 1
+retract_before_wipe = 0%
+retract_layer_change = 1
+retract_length = 1
+retract_length_toolchange = 1
+retract_lift = 0
+retract_lift_above = 0
+retract_lift_below = 0
+retract_restart_extra = 0
+retract_restart_extra_toolchange = 0
+retract_speed = 40
+silent_mode = 0
+single_extruder_multi_material = 0
+start_gcode = M104 S0\nM140 S0\nPRINT_START BED={first_layer_bed_temperature[0]} EXTRUDER={first_layer_temperature[0]}
+thumbnails = 64x64,400x300
+toolchange_gcode = 
+use_firmware_retraction = 0
+use_relative_e_distances = 1
+use_volumetric_e = 0
+variable_layer_height = 1
+wipe = 0
+z_offset = 0
+extruder_clearance_height = 25
+extruder_clearance_radius = 45
+